Routine Oil Changes - Frymaster FilterQuick 5FQG30U Installation, Operation And Maintenance Manual

3.4.2

Routine Oil Changes

When the oil reservoir level is low, the controller displays TOPOFF OIL EMPTY in the left display
and CONFIRM in the right display. Press  (CONFIRM). Some procedures may differ from photos
shown. If using solid shortening see Appendix C for instructions. Follow manufacturer's instructions
for changing the JIB.
1. Open the cabinet and slide the JIB from
the cabinet (see Figure 2).
Figure 2
3. With the jug upright remove the cap and
foil seal (see Figure 4).
Figure 4
WARNING:
HOT or USED oil to a JIB.
3.4.3 Bulk Oil Systems
Instructions for installing and using bulk oil systems are found in Appendix A locat-
ed at the rear of this manual.
Do not add
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 3).
4. Put the tube in the new full container (see Figure 5).
5. Slide the JIB onto the shelf inside the fryer cabinet
(as seen in Figure 2).
6. Press and hold the orange JIB reset switch ten (10)
seconds to reset the top off system. (see Figure 6).
3-6
Figure 3
Figure 5
Figure 6
Image and location may differ
from photo.