Download Print this page

Storage Recommendations; Charging Procedure - Stanley STDC411L Manual

Advertisement

Available languages

Available languages

ENGLISH
This will reduce risk of damage to electric plug
charger.
and cord.
Make sure that cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
Do not use an extension cord unless it is absolutely
Use of improper extension cord could result in
necessary.
risk of fire, electric shock, or electrocution.
An extension cord must have adequate wire size for
The smaller the gauge number of the wire, the
safety.
greater the capacity of the cable, that is 16 gauge has
more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each
individual extension contains at least the minimum wire
size.
Do not place any object on top of charger or place the
charger on a soft surface that might block the
ventilation slots and result in excessive internal heat.
Place the charger in a position away from any heat
The charger is ventilated through slots in the top
source.
and the bottom of the housing.
Do not operate charger with damaged cord or plug —
have them replaced immediately.
Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way.
Take it to an authorized service center.
Do not disassemble charger;
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock,
electrocution or fire.
Disconnect the charger from the outlet before
attempting any cleaning.
electric shock. Removing the battery pack will not reduce
this risk.
NEVER attempt to connect 2 chargers together.
The charger is designed to operate on standard
household electrical power. Do not attempt to use it
on any other voltage.
SAVE THESE INSTRUCTIONS
Important Safety Instruction for Battery Packs
For safe operation, read this manual and
WARNING:
manuals originally supplied with tool before using the
charger.
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the safety
instructions below. Then follow charging procedures
outlined.
Read all Instructions
Do not incinerate the battery pack even if it is
severely damaged or is completely worn out.
battery pack can explode in a fire. Toxic fumes and
materials are created when LI-ION battery packs are
burned.
6
take it to an authorized
This will reduce the risk of
The
Do not charge or use battery in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust.
from the charger may ignite the dust or fumes.
If battery contents come into contact with the skin,
immediately wash area with mild soap and water.
battery liquid gets into the eye, rinse water over the open
eye for 15 minutes or until irritation ceases. If medical
attention is needed, the battery electrolyte for Li-ion
batteries is composed of a mixture of liquid organic
carbonates and lithium salts.
Contents of opened battery cells may cause
respiratory irritation.
persists, seek medical attention.
WARNING: Burn hazard.
flammable if exposed to spark or flame.
Charge the battery packs only in
DO NOT splash or immerse in water or other liquids.
This may cause premature cell failure.
Do not store or use the tool and battery pack in
locations where the temperature may reach or exceed
105°F (40C°) (such as outside sheds or metal
buildings in summer).
Never attempt to open the battery pack for
WARNING:
any reason. If battery pack case is cracked or damaged,
do not insert into charger. Do not crush, drop or damage
battery pack. Do not use a battery pack or charger that
has received a sharp blow, been dropped, run over or
damaged in any way (i.e., pierced with a nail, hit with a
hammer, stepped on). Damaged battery packs should be
returned to service center for recycling.
WARNING: Fire hazard. Do not store or carry battery
so that metal objects can contact exposed battery
For example, do not place battery in aprons,
terminals.
pockets, tool boxes, product kit boxes, drawers, etc., with
loose nails, screws, keys, etc.
can possibly cause fires if the battery terminals
inadvertently come in contact with conductive
materials such as keys, coins, hand tools and the like.
NOTE: LI-ION batteries should not be put in checked
baggage.

STORAGE RECOMMENDATIONS

1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold.
2. Long storage will not harm the battery pack or charger.

CHARGING PROCEDURE

Stanley chargers are designed to charge
Stanley battery packs in 40-60 minutes depending on the pack
being charged.
1. Plug the charger into an appropriate outlet before
inserting the battery pack.
2. Insert the battery pack into the charger. (Fig. B)
3.
The LED will flash indicating that the battery is
Inserting or removing the battery
Provide fresh air. If symptoms
Battery liquid may be
chargers.
Stanley
Transporting batteries
If
5

Advertisement

loading