Panasonic AJ-HD1700PE Operating Instructions Manual page 37

Variable memory function
Variable memory editing operation procedure
9
POWER OFF ON
1 2 3 4 5 6 7 8 CUE
CH
CH CONDITION MONITOR FULL/FINE REMOTE
9P 50P RS-232C
L R
HEADPHONES
SHIFT F1 F2 F3 F4
ABC DEF GHI
AUDIO CH SELECT
7 8 9
1 5 2 6 3 7 4 8 PREVIEW/ PRE-
CH CH CH CH CH CH CH CH
JKL MNO PQRS REVIEW ROLL
4 5 6 BS
AUTO
TUV WXYZ
EDIT
1 2 3 ENT
PUSH
LOCK
0 C T F
REC P8 REC P8 REC P8 REC P8
FULL
8
To perform variable memory editing operations, set
this VTR, which is connected as the recorder to the
variable memory mode, and take the steps below.
1
Select the editing mode on the <ASSEMBLE> or
<INSERT> menu.
2
Select the VTR to be operated by pressing the
RECORDER or PLAYER button.
3
Register the IN and OUT points using the SET
button and IN and OUT buttons. The player's OUT
point cannot be registered.
4
Press the PLAYER button to select the player
VTR, and then set the initial speed using the
search dial while holding down the SET button.
5
When the SET button and PREVIEW/REVIEW
button are pressed at the same time, the tapes in
both the player and recorder are automatically
prerolled, and the player VTR plays back the tape
at the initial speed setting up to the IN point.
6
After the tape has passed the IN point, turn the
search dial to store the playback speed of the
player VTR in the memory.
7
When the tape passes the OUT point that was set
by the recorder, the storing of the playback speed
in the memory ends.
4 6
5 1
EJECT
XL/L/M -cassette
Do not insert S-cassette
without adapter
SHTL JOG VAR
ADJUST
HOME RF1 RF2 ASSEM
PUSH-INTER
VIDEO UNITY TC CUE
INSERT
REV FWD
AUDIO UNITY DIAG MENU
STAND BY PLAYER RECORDER INPUT CHECK
F5 F6
SERVO REC INHIBIT
EDIT PLAY REC
A IN A OUT
TRIM
REW STOP FF
SET
IN OUT
3 2
8
When the AUTO EDIT button is pressed, variable
memory editing is executed. Once editing has
been executed, the memorized speeds will be
cleared except for the initial speed which is not
cleared.
9
By pressing the PREVIEW/REVIEW button, the
edited results can be checked.
<Notes>
FULL
• Whatever is stored in the memory will be cleared
when the VTR exits the variable memory mode. It
is also cleared when the POWER switch is set to
"OFF."
• Phase synchronization is not performed during
playback up to the IN point of the variable memory
editing. Therefore, depending on the VTR used as
the player and its speed setting, no guarantees are
made for the accuracy of the IN point.
• When conducting variable memory editing in the
speed range of j1.0k to i2.0k, use VTRs with
which these speeds are guaranteed for both the
recorder and player.
37