Table of Contents
Advertisement
2. Installation
To install the interface, first switch off the ignition and disconnect the vehicle's battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation
2.1.1. Place of installation – video interface and CAN-bus box
The interface box and the CAN-bus box are prepared to be connected behind the vehicle`s
monitor and head-unit. Both parts have to be removed for the installation
Version 25.09.2019
HW: 25-10
VL2-MTC
Advertisement
Table of Contents
Need help?
Do you have a question about the VL2-MTC and is the answer not in the manual?
Questions and answers