Setting - Eiki EK-351WST Owner's Manual

Setting

The projector comes with convenient adjustment function.
1 Press the MENU button on remote controller and the OSD displays. Press
Setting icon, press
2 Press button to point to required item and press OK button to confirm the selection.
On start
Setting the projector to be turned on automatically
just by connecting the AC power cord.
On .......... Start the projection with countdown
immediately.
Off .......... Start up in the standby mode.
Standby mode
Press button to select the item below:
Eco.......... Restrict some functions in the standby
mode to reduce power consumption.
In this case, you cannot use network
functions and RS-232C commands
(expect Power ON).
Normal ... No restrict network and serial communication function via "Wake on LAN" software
while the standby mode.
High land
Control the fan speed through the Setting menu.
Off ...... Normal speed. Set it so if the projector is operated at normal altitude.
On ...... Faster speed than the setting as "Off". Set it so if the projector is operated at high altitude.
Note:
● Please change the setting as "ON", while operating the projector at an altitude around 1400 ~
2700m.
Light source control
Change the brightness of the projection.
Normal .... Normal brightness.
Eco .......... Lower brightness, reducing power consumption and extending the life time of the
light source.
Cooling fast
provides the following options in the cooling fans' operation after turning off the projector.
Normal ..............With 60 sec. cooling time.
30 sec .............. Faster cooling time and louder noise of fan.
0 sec.(Default) ... Allow to unplug the AC power cord
immidiately without the cooling.
Closed caption (Video signal only)
Allows the subtitle to be displayed for the audio
contents or other information. If the input source
contains closed caption, you can enable this
function and change the channel. Press  to
select Off, CC1, CC2, CC3 or CC4.
Note:
● Closed caption is disable when screen menu or
Timer displayed on screen.
OSD setting-Setting
button or OK button to confirm the selection.
Setting
On start
Standby mode
High land
Light Sourcecontrol
Cooling fast
Closed caption
Key lock
Contrast optimization
Sound
HDMI Setup
Setting
On start
Standby mode
High land
Light source control
Cooling fast
Closed caption
Key lock
Contrast optimization
Sound
HDMI Setup
button to select
Off
Eco
Off
Normal
Off
On
Off
Eco
Off
Normal
Off
On
41