Remote Controller Operation Range; Install Battery Of Remote Controller - Eiki EK-351WST Owner's Manual

Name and function of the projector

Install battery of remote controller

① Open the battery
cover.
To ensure safe operation, please observe the following precautions:
● Use two (2) AAA or LR3 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked in the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if two batteries are replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.
Operation range of remote controller
Point the remote controller to the IR receiver
of the projector
Maximum operation range of the remote con-
troller is an area of radius 5 meters / arc 30°
in front of and behind the projector
Adjustable pad
The projector can be adjusted up to 4 degree
with the adjustable foot.
Rotate the adjustable foot to lift the projector
to a certain height. During lifting, rotate the
foot clockwise.
To lower or retract the adjustable foot, rotate
the foot counterclockwise.
② Install new batteries.
B
A
D
Two AAA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
15°
15°
Adjustable foot
C
③ Put the cover
back.
15°
15°
17