Transport - Lenze M55BH063S04 Mounting And Switch-On Instructions

Transport

Transport
Ensure appropriate handling.
•
Make sure that all component parts are securely mounted. Secure or remove loose
•
component parts.
Only use safely fixed transport aids (e.g., eye bolts or support plates).
•
Do not damage any components during transport.
•
Avoid electrostatic discharges on electronic components and contacts.
•
Avoid impacts.
•
Check the carrying capacity of the hoists and load handling devices. The weights can be
•
found in the shipping documents.
Secure the load against tipping and falling down.
•
Standing beneath suspended loads is prohibited.
•
The transport weights can be found in the shipping documents!
The motors mounted on the gearbox are sometimes equipped with ears. These
are exclusively intended for mounting the motor on/removing the motor from
the gearbox and must not be used for the complete geared motor!
CAUTION!
Danger from tipping or falling loads!
Standing beneath suspended loads is prohibited!
▶ Use additional appropriate lifting aids, if required, to achieve a direction of loading which is
as vertical as possible (highest load carrying capacity). Secure lifting aids against shifting!
▶ Screw in the transport aids completely. They must have even and full-surface contact!
▶ Transport aids must be loaded vertically in the direction of the screw axis! Diagonal or
lateral tension reduces the load carrying capacity! Observe data in standard DIN 580!
The thread in the output shaft can be used with smaller drives. Larger gearboxes have a
transport thread for eye bolts in accordance with DIN 580 in the gearbox housing as standard.
The eye bolt is not included in the scope of supply!
The position of the transport thread can be seen in the following representations.
Position of the eye bolt
G50AB045...G50BB124
1.
2.
16
from G50BB145
1.
2.