18" SHALLOW DEPTH SERIES
Operation / Installation Manual
GENERAL PRECAUTIONS
DANGER
1. Risk of child entrapment. Before you throw
away your old unit, take off the doors and
leave shelves in place so children may not
easily climb inside.
2. Altering or cutting of the power cord, or
removal of the power plug, or direct wiring
can cause serious injury, fire and/or loss
of property and/or life and will void the
warranty.
WARNING
1. Never
attempt
to
maintenance on the unit until the electricity
has been disconnected.
2. The anti-tip kit must be installed on this unit
before it is used. Never use the shelves or
doors as steps or to support more than they
are designed to support.
INSTALLATION INSTRUCTIONS
GENERAL
1..All. electrical. instructions. assume. that. outlet. is.
located.4-10.inches.from.the.floor.
2..Floor.must.be.level.in.area.of.installation..Leg.
levelers.are.used.for.fine-tune.adjustment.only.
and.should.not.be.used.to.compensate.for.floor.
differences.exceeding.1/2".
3..When. moving. unit. into. position,. take. care. to.
protect. floor. surface. with. cardboard,. rugs,. etc.
(see.page.4).
4..Never. attempt. to. move. unit. without. aid. of. at.
least.one.other.person.
5..Always. secure. doors. shut. prior. to. moving. the.
unit.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice
repair
or
perform
2
CAUTION
1. Do not lift unit by shelves or door handle.
2. Failure to clean the condenser every three
months can cause the unit to malfunction.
This could void the warranty.
3. Never install the unit behind closed doors (ie:
closets, small, etc). Be sure front louvered
toe plate is free of obstruction. Obstructing
free air flow can cause unit to malfunction
and may void the warranty.
4. Use only Perlick replacement parts. Imitation
parts can damage the unit, and may void the
warranty.
FINISHED ROUGH OPENING REQUIREMENTS
1..Height:.
32-1/2"
2..Depth:.
18"
3..Width:.
24"
Need help?
Do you have a question about the Shallow Depth HH24WS-1X and is the answer not in the manual?
Questions and answers