Related Manuals for Perlick HP15TS/TO
Summary of Contents for Perlick HP15TS/TO
- Page 1 Installation Manual for Beer Dispensing Equipment HP15TS/TO 15” SIGNATURE SERIES HP24TS/TO 24” SIGNATURE SERIES HC24TB/TO 24” C-SERIES Form No. Z2349 Rev. 03/05/2014...
- Page 2 For your own protection, never return merchandise for WARNING experienced personnel to handle credit without our approval. high pressure gas. We thank you again for selecting a high quality Perlick Beer Do not apply oil to the regulator! Dispenser. Cheers! WARNING perlick.com...
- Page 3 Remove any obstructions from the access hole of the refrigerator. Follow instructions on pages 4 through 7 to properly install the tapping equipment on your perlick unit. Dispensing Head...
- Page 4 PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT NOTE: Wash tapping devices thoroughly. Flush beer and faucet lines, as well as the tapping device (keg coupler) with fresh water. 1. Locate the dispensing head , black beer line(s), and hose clamp(s). Slide one end of each beer line onto the stainless steel tubes which protrude out the bottom of the dispensing head and clamp tight.
- Page 5 PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT 4. If installing a two or three faucet system, a CO2 manifold will need to be installed. Locate the red CO2 lines, CO2 manifold and a #10 x 1/2” sheet metal screw. Slide one end of each hose onto the barbed fittings on the manifold and clamp.
- Page 6 PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT 7. On the right rear sidewall there is a double column of screws. Remove the center screw. Locate the safety chain and a #10 x 1/2” sheet metal screw from the parts bag. Insert the screw through the closed end link of the chain and tighten in the vacant screw hole.
- Page 7 PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT 10. Before tapping, make sure the beer faucet is closed. To tap a keg, insert the coupler into the fitting on top of the barrel. Turn the coupler clockwise until it stops (about an 1/8 turn), then push down on the top of the coupler and again turn clockwise until it stops.
- Page 8 PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT CONNECTING THE REGULATOR TO THE CO2 CYLINDER 1. Remove the blue plug from the regulator fitting, but do not remove the carbonic washer. 2. Screw regulator onto gas cylinder valve. Tighten with wrench until vertically straight.
- Page 9 PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT perlick.com...
- Page 10 Contact Perlick Customer or Technical Service at 800.558.5592. Customer Service and Technical Service are available business days Monday through Friday from 8 a.m. to 4:30 p.m. CST. 8300 W. Good Hope Road, Milwaukee, WI 53223 • 800.558.5592 • info@perlick.com • www.perlick.com Form No. Z2349 Rev. 03/05/2014...