Table of Contents
Advertisement
3
Installation
Refer to the nearest Authorised Service
Agent for installation of your product.
To make the product ready for use,
make sure that the electricity, tap water
supply and water drainage systems are
appropriate before calling the Authorised
Service Agent. If they are not, call a
qualified technician and plumber to have
any necessary arrangements carried out.
C
Preparation of the location
and electrical, tap water and
waste water installations at
the place of installation is the
customer's responsibility.
B
Installation and electrical
connections must be carried
out by the Authorised Service
Agent. Manufacturer shall
not be held responsible for
damages arising from processes
carried out by unauthorised
persons.
A
Prior to installation, visually
check if the product has any
defects on it. If so, do not
have it installed. Damaged
products cause risks for your
safety.
C
Make sure that the water inlet
and discharge hoses are not
folded, pinched or crushed
while pushing the product into
its place after installation or
cleaning procedures.
When placing the product, pay attention
not to damage the floor, walls, piping,
etc. Do not hold the product by its door or
panel to move it.
Dishwasher / Instruction Manual
Appropriate installation
location
•
Place the product on a solid and
flat floor that has sufficient load
carrying capacity! The product must
be installed on a flat surface in order
for the door to be closed comfortably
and securely.
•
Do not install the product at places
where temperature may fall below
0ºC.
•
Place the product at least 1 cm away
from the edges of other furniture.
•
Place the product on a rigid floor.
Do not place it on a long pile rug or
similar surfaces.
B
Do not place the product on
the power cable.
•
Make sure that you select a location
that will allow you to load and unload
the dishes in a fast and comfortable
manner.
•
Install the product in a place close to
the tap and the drain hole. Select the
installation location by considering
that it will not be changed after the
connections are made.
Connecting water supply
C
We recommend attaching a
filter on the house/apartment
supply water inlet to protect
the machine from damages
that may arise from impurities
(sand, dirt, rust, etc.) coming
from the urban water supply
system or from your own water
system as well as to prevent
complaints such as yellowing
or sludge accumulation at the
end of washing.
9 / 42 EN
Advertisement
Table of Contents
