Adjusting The Amount Of Rinse Aid; Programme Follow-Up; Cancelling The Programme; Salt Indicator - Elba EBDW 1351 AW Instruction Manual

Operating the product

Programme follow-up

You can track the current step of the
selected programme on the programme
step lights located on the control panel.
C
If the drying light is on, the
machine will perform silent
drying for 30-60 minutes. At
the end of this period, the
Drying light will go off and the
End light will become on.
The End light will become on when the
selected washing programme ends.

Cancelling the programme

1. Press and hold the Start / Pause /
Cancel key for 3 seconds to cancel the
programme.
2. Release it when the Washing and
Drying lights start flashing. Water in
the machine will be discharged in 45
seconds. The programme will have
been cancelled once the Washing and
Drying lights go off and the End light
becomes on. Then, you can select and
operate a new programme.
C
There might be residues of
detergent or rinse aid left in
the machine and/or on the
pieces being washed depending
on the step in which the
programme has been cancelled.
C
When you set the Programme
Selection Knob to "Off"
position, the washing
programme will end and the
machine will be ready for a
new programme selection. If
you end the washing cycle this
way, water and detergent may
remain in the machine.
32 /42 EN

Salt indicator

Please check the salt indicator to see
whether there is adequate amount of
softening salt in the dishwasher or not.
You need to refill the salt reservoir with
salt whenever the no-salt warning symbol
lights.
C
Adjusting the water hardness
level is explained in Water
Softening System section.

Rinse Aid indicator

Please check the rinse aid indicator to see
whether there is adequate amount of rinse
aid in the dishwasher or not. You need to
refill the rinse aid dispenser with rinse aid
whenever the no rinse aid warning symbol
lights.
Adjusting the amount of rinse
aid
1. While the Programme Selection Knob
is in "Off" position, press and hold the
function key and turn the Programme
Selection Knob clockwise by one level,
keeping the function key pressed for
2 seconds. At the end of this time,
the machine will enter the rinse aid
adjustment mode.
2. Once the machine has entered the
rinse aid adjustment mode, the stored
rinse aid level will be shown on the
programme follow-up LEDs for 5
seconds.
3. For the new Rinse Aid setting, set
the Programme Selection Knob to the
relevant position.
4. Press Start / Pause / Cancel key for
once to store the level you have
selected.
Dishwasher / Instruction Manual