Connection To The Drain; Adjusting The Feet - Elba EBDW 1351 AW Instruction Manual

Installation
Permitted water temperature: up to
25°C
The dishwasher may not be connected to
open warm water devices or flow-through
water heaters.
•
Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied with
the product.
•
Connect the water inlet hose directly
to the water tap. Pressure coming
from the tap should be minimum 0.3
and maximum 10 bars. If the water
pressure exceeds 10 bars, a pressure
relief valve should be installed in
between.
•
Open the taps completely after
making the connections to check for
water leaks.
C
Use a screw-on hose connector
to connect the water inlet
hose to a water tap with a
¾ inch external thread. If
required, use a filter insert to
filter deposits from the pipes.
A
For your safety, close the
water inlet tap completely
after the washing programme
is over.

Connection to the drain

Water discharge hose can directly be
connected to the drain hole or sink's
10 /42 EN
drainage. The length of this connection
must be min. 50 cm and max. 100 cm from
the floor. A discharge hose longer than 4
meters causes dirty washing.
Attach the water discharge hose to the
drainpipe without bending it. Tightly fix
the water discharge hose to the drainpipe
in order to prevent any dislocation of the
water discharge hose during operation of
the product.
C
Drainpipe must be connected
to the sewage system and it
should not be connected to any
surface water.

Adjusting the feet

If the door of the product cannot be
closed properly or if the product swings
when you push it slightly, then you need
to adjust the feet of the product. Adjust
the feet of the product as illustrated in
the installation manual supplied with the
product.
A
Diswashers door must be
aligned properly otherwise hot
steam can escape! Danger of
serious burns, other injury or
may damage furniture.
Dishwasher / Instruction Manual