Table of Contents
Advertisement
TROUBLESHOOTING > When any problem appears
No sound is coming from a specific speaker
(
The playback source does not contain a signal for the channel.
To check it, display information about the current audio signal on the TV. For details, see the following:
"Checking the audio signal information" (p.241)
(
(
The currently selected sound program/decoder does not use the speaker.
To check it, use "Test Tone" in the "Setup" menu. For details, see the following:
"Outputting test tones" (p.239)
(
(
Audio output of the speaker is disabled.
Perform YPAO or use "Configuration" in the "Setup" menu to change the speaker settings. For details,
see the following:
"Flow of the speaker configurations" (p.115)
(
"Setting the use of a subwoofer" (p.231)
(
"Setting the use of each speaker and its size" (p.226)
(
(
The volume of the speaker is set too low.
Perform YPAO or use "Level" in the "Setup" menu to adjust the speaker volume. For details, see the
following:
"Flow of the speaker configurations" (p.115)
(
"Adjusting the volume of each speaker" (p.235)
(
(
The speaker cable connecting the unit and the speaker is broken.
Check the unit's SPEAKERS terminals and the speaker's terminals. If there is no problem with the
connection, replace a broken speaker cable with another speaker cable.
(
The speaker is malfunctioning.
To check it, replace with another speaker. If the problem persists with using another speaker, the unit
may be malfunctioning.
366
Advertisement
Table of Contents
