Table of Contents
Advertisement
PLAYBACK > Listening to the radio
Preparing the DAB tuning
Model For
U.K., Europe, Russia and Australia
Before listening to DAB (Digital Audio Broadcasting) radio, perform an initial scan to register the DAB radio
stations automatically.
1
Select "TUNER" as the input source.
2
Press BAND to select the DAB band.
3
Press [jTUNING] to start an initial scan.
When the initial scan finishes, the unit automatically tunes in to the first DAB radio station in
order by frequency.
NOTE
DAB uses digital signals for clearer sound and more stable reception compared to analog signals. The unit can also receive DAB+
(
(an upgraded version of DAB) that allows for more stations using MPEG-4 HE-AAC v2 audio codec, which has a more efficient
transmission method.
Be sure to check the DAB coverage in your area in that not all areas are currently being covered. For a list of nationwide DAB
(
statuses and worldwide DAB frequencies, check WorldDMB online at http://www.worlddab.org/.
If no DAB radio stations are found by an initial scan, the front display will change to the initial Scan menu. Press [jTUNING] to
(
start an initial scan again.
You can check reception strength of each DAB channel label. Press MODE two times to view the Tune AID menu. Then, select the
(
desired DAB channel label. The reception strength of DAB channel label is displayed in 0 (none) to 100 (best).
To perform an initial scan again after some DAB radio stations are stored, press MODE. If you perform an initial scan again, the DAB
(
radio stations currently registered to the preset numbers will be cleared.
n
DAB frequency information
The unit supports Band III (174 to 240 MHz) only.
Frequency
174.928 MHz
176.640 MHz
178.352 MHz
180.064 MHz
181.936 MHz
183.648 MHz
185.360 MHz
187.072 MHz
188.928 MHz
157
Channel label
5A
5B
5C
5D
6A
6B
6C
6D
7A
Advertisement
Table of Contents
