Table of Contents
Advertisement
Camera menu items (continued)
IP Network screen
IP Net wo rk
IP Addr ess
Su bnet Mas k
De fault Ga te wa y
Re turn
IP Address
This is selected to display the IP address which has been set for the
unit.
Subnet Mask
This is selected to display the subnet mask which has been set for
the unit.
Default Gateway
This is selected to display the default gateway which has been set for
the unit.
<NOTE>
• On this screen, the [IP Address], [Subnet Mask] and [Default Gateway]
settings can be displayed but they cannot be changed.
To change an address, use "Network setup screen [Network]"
(→ page 86) on the Web setting screen [Setup] or "Use the Easy IP
Setup Software to establish the unit's settings" (→ page 21).
Return
Return to the previous menu level.
Concerning initialization
„
z
When [Initialize] is selected on the [Maintenance] screen, the [Initialize]
screen appears.
Initialize screen
Ini tia li ze
Do you wan t to in it i al iz e
Me nu se tti ng s?
CA NCEL
O. K.
• When the cursor is moved to [O.K.] on the [Initialize] screen and the
setting is entered, the [Menu settings initialized] screen is displayed for
5 seconds, and the camera settings are restored to the settings which
were established when the camera was purchased.
However, the [Format] settings, [Frequency] settings and [Install
Position] settings (→ page 47, page 48) and network settings are
not initialized.
<NOTE>
• Operation returns to the [Top Menu] screen when the initialization
operation is completed. At this point, set the unit to the Standby mode,
and then set it to the Power ON mode again. (→ page 23)
• The [Format], [Frequency] and [Install Position] settings are not
initialized.
• The [AWB] and [ABB] adjustment values are not initialized.
19 2. 1 68 .
0. 1 0
25 5. 2 55 .2 5 5.
0
19 2. 1 68 .
0.
1
Menu settings initialized screen
M en u s e tt in g s
i ni t ia l iz ed
• When the cursor is moved to [CANCEL] on the Initialize screen
and the setting is entered, the [Menu settings unchanged] screen is
displayed for 5 seconds, the initialization operation is not performed,
and the [Maintenance] screen returns to the display.
Menu settings unchanged screen
M en u s e tt in g s
u nc h an g ed
52
Advertisement
Table of Contents
