Table of Contents
Advertisement
Manual shooting
Manually adjusting the focus
The lens focus can be adjusted manually.
When using an AW-RP50, AW-RP120, or AK-HRP200
Refer to the operating instructions for the controller.
<NOTE>
• When the focus is set to manual, the subject may go out of focus
during panning, tilting and zooming. Therefore, the unit comes with a
function which compensates for this. (Focus ADJ With PTZ.)
This function was set to [On] at the factory.
If the function has been set to [Off], either adjust the focus, as
required, after zooming or set the focus to auto.
(→ page 49, page 78, page 81)
Manually adjusting the iris
The lens iris can be adjusted manually.
When using an AW-RP50, AW-RP120, or AK-HRP200
Refer to the operating instructions for the controller.
<NOTE>
• In the night mode, the iris is set to open as a measure to prevent video
spying.
Adjust the brightness at the light source.
Preset memories
This unit enables up to 100 settings for the camera direction (panning
and tilting), zoom, focus, iris, gain, white balance and digital extender to
be registered in its preset memories, and called.
However, the number of settings that can be registered and called
depends on the type of controller that is used for operation.
• The focus and iris operating modes (manual and auto settings) are
neither registered nor recalled. The current focus and iris values are
registered.
• The focus and iris values can be recalled only when the manual
settings are applicable.
• For the white balance, the current White Balance Mode adjustment
values are registered. If a preset value is recalled when AWB A
or AWB B is selected, the adjustment value selected when it was
registered as a preset will be recalled. The R Gain and B Gain values
return to 0 in such cases.
<NOTE>
• When there is a large difference in the environmental temperature
between the time of registration and the time the setting is called,
displacement of the preset position may occur.
• If displacement occurs, perform registration again.
• When a manual operation is performed for pan, tilt, zoom, focus or iris
during preset recall, the preset operation for the pan, tilt, zoom, focus
or iris operation concerned will be aborted.
• If another preset has been recalled during an ongoing preset recall,
the preset being recalled is aborted, and operation for the preset called
last is performed instead.
Manually adjusting the shutter speed
The shutter speed can be set using two methods. One is a method that
specifies the time (where a time such as 1/250 sec. is designated), and
the other is a method that specifies the frequency (where synchro scan,
60.15 Hz, etc. is designated).
When shooting a TV screen or personal computer's monitor screen, the
horizontal noise generated when the screen is shot can be minimized by
adjusting the frequency to the screen frequency using synchro scan.
The procedure is the same as for "Basic setup operations"
(→ pages 30 to 37).
When using an AW-RP50, AW-RP120, or AK-HRP200
Refer to the operating instructions for the controller.
Manually adjusting the gain
There are two ways to adjust the gain. One way involves using the
buttons on the controller; the other way involves using the Camera menu
or Web setup screen [Setup]. The gain can be adjusted more precisely
using the Camera menu or Web setup screen [Setup].
For further details, refer to the "Gain" (→ page 40, page 72).
<NOTE>
• When adjusting the gain, the light quantity may change suddenly
(causing the image output to be subjected to a shock).
When using an AW-RP50, AW-RP120, or AK-HRP200
Refer to the operating instructions for the controller.
In any case, the maximum gain of the automatic adjustment (AGC) can
be set by the camera menu or Web setup screen [Setup].
For further details, refer to the "AGC Max Gain" (→ page 40,
page 73).
When using an AW-RP50 or AW-RP120
Up to 100 entries can be registered/recalled.
For details, refer to the operating instructions for the controller.
When using an AK-HRP200
Preset memories cannot be registered or recalled.
27
Advertisement
Table of Contents
