Table of Contents
Advertisement
Displaying the web screen (continued)
<NOTE>
• If the personal computer does not have the plug-in viewer software
already installed, an installation confirmation message is displayed
before the live screen [Live] is displayed. In a case like this, follow
the on-screen instructions to install the software.
For further details, refer to "Installing the plug-in viewer software"
(→ page 22).
• When [User auth.] (→ page 84) is set to [On], the user name and
password input screen is displayed before the live screen [Live]
appears.
The default settings for the user name and password are as follows.
User name
admin
Password
12345
• While the initial settings remain used for the user name and
password, a message prompting the user to change the user
name and password is displayed after authentication. In order to
ensure security, the password for the user name of "admin" must be
changed without fail. It is also recommended that the password be
changed at regular intervals.
• When an attempt is made to display multiple H.264 images on one
personal computer, IP videos may not be displayed depending on
the performance of the personal computer concerned.
• When an item which is underlined on the screen is clicked, a
separate window opens, and an input example is displayed.
• Up to 14 users (consisting of users receiving H.264 images and
users receiving JPEG images) can access the unit at the same
time. However, the number of users that can access the unit may
be less than 14 depending on the [Bandwidth control (bit rate)]
and [Max bit rate (per client)] settings. A message indicating the
access limit will appear if the number of users exceeds 14. When
[Transmission type] is set to [Multicast port] for [H.264], the second
and subsequent users receiving H.264 images will not be counted
toward the total access count.
• When [H.264 transmission] (→ page 68) is set to [On], H.264
images are displayed. When it is set to [Off], JPEG images will
be displayed. JPEG images can be displayed even when [H.264
transmission] is set to [On]. In such cases, however, the maximum
frame rate of the JPEG images will be 5 fps.
• The JPEG image frame rate may be slower depending on the
network environment, performance of your personal computer,
subject of the video, and access volume.
<JPEG image frame rate>
When [H.264 transmission] is set to [On]
Up to 5 fps
When [H.264 transmission] is set to [Off]
Up to 30 fps
Switching between the Live screen [Live] and
Web setup screen [Setup]
When the live screen [Live] is displayed, click the
For details on the web setup screen [Setup], see "Web setup screen
[Setup]" (→ page 65).
When the web setup screen [Setup] is displayed, click the
button.
For details on the live screen [Live], see "Live screen [Live]"
(→ page 60, page 64).
<NOTE>
• During Standby mode, the [Setup] button is disabled, and you cannot
switch to the web setup screen [Setup].
• If the unit is switched to Standby mode from another terminal while the
web setup screen [Setup] is displayed, the display will switch to the
live screen [Live] after a few seconds.
59
button.
Advertisement
Table of Contents
