Table of Contents
Advertisement
Web screen configurations (continued)
Recommended network setting for internet
Perform the recommended settings to connect the camera to the
Internet.
Clicking the [Set] button displays a dialog box telling the user that item
settings will be changed. After confirming this, click the [OK] button.
• Camera image's "JPEG/H.264" tab
JPEG(1)
Image capture size: 640×360
JPEG(2)
Image capture size: 320×180
JPEG(3)
Image capture size: 160×90
H.264(1) • H.264(2) • H.264(3) • H.264(4)
Internet mode (over HTTP): On
Transmission priority: Best effort
H.264(1)
Image capture size: 1280×720
Max bit rate (per client): Max1024 kbps, Min1024 kbps
H.264(2)
Image capture size: 640×360
Max bit rate (per client): Max1024 kbps, Min128 kbps
H.264(3)
Image capture size: 320×180
Max bit rate (per client): Max1024 kbps, Min128 kbps
H.264(4)
Image capture size: 160×90
Max bit rate (per client): Max1024 kbps, Min128 kbps
• "Network" tab in the Network setting screen
Common IPv6/v4
Max RTP packet size: Limited(1280 byte)
HTTP max segment size(MSS): Limited(1280 byte)
Advanced network setting screen [Advanced]
„
z
Click the [Advanced] tab in the network setup screen [Network].
Settings relating to the NTP, UPnP, HTTPS, SNMP, and RTSP functions
are performed here.
Click the links to each item to move to the respective setting page.
z NTP
z
Settings relating to the NTP server address and port No. are
performed here.
Time adjustment
Sets the method to adjust the time. The adjusted time will be used as
this unit's standard time.
Setting value:
Manual
Synchronization with
NTP server
Factory settings: Synchronization with NTP server
NTP server address setting
Select the method to acquire the NTP server address.
Setting value:
Auto
Acquires the NTP server address from the DHCP server.
Sets the address by inputting the NTP server address in
Manual
[NTP server address].
Factory settings: Manual
<NOTE>
• To acquire the NTP server address from the DHCP server,
[Network Settings] (→ page 87) must be set to either [DHCP],
[Auto(AutoIP)] or [Auto(Advanced)] in the [Network] tab of the
network setup screen [Network].
NTP server address
When [Manual] is selected in the [NTP server address setting], input
the IP address or host name of the NTP server.
Maximum number
1 to 128 half-size characters
of characters
Characters that
Half-size alphanumeric characters, half-size symbols
can be entered
:. _ -
Factory settings: blank
<NOTE>
• To input the [NTP server address] host name, the [DNS] setting
must be selected on the [Network] tab of the network setup screen
[Network] (→ page 87).
89
The time set in [Date/time] of the Basic screen
will be used as this unit's standard time.
The time adjusted automatically through
synchronization with the NTP server will be
used as this unit's standard time.
Advertisement
Table of Contents
