enphase Q 7 Micro Installation And Operation Manual page 27

J. Add the new microinverter serial number to the Envoy database by initiating a device scan
using one of the following methods:
a. Method 1: Initiate a scan using the Installer Toolkit mobile app
•
In Installer Toolkit, once connected to the IQ Envoy, navigate to the Overview screen.
•
From the Overview screen, tap Detected > Start Device Scan to start a new 30-
minute device scan.
•
If device scanning on the IQ Envoy is inhibited, the app displays Scan Inhibited. If
you need to add more microinverters to the system when device scanning is inhibited
on the IQ Envoy, you must use the Installer Toolkit scanning tool to provision them on
the IQ Envoy, rather than using the IQ Envoy's device scanning function to discover
them. If this is not possible and you need to enable device scanning on the IQ Envoy,
contact Enphase Customer Support at
b. Method 2: Use an IQ Envoy
•
Press the Device Scan button on the IQ Envoy. The IQ Envoy begins a 15-minute
scan to identify all of the microinverters deployed at the site. The Microinverter
Communications LED
K. Log in to Enlighten to use Enlighten's Array Builder to add the newly detected microinverter to
the virtual array.
L. Ship the old microinverter to Enphase using the supplied return-shipping label.
27
flashes green during the scan.
© 2018 Enphase Energy Inc. All rights reserved.
IQ 7 / IQ 7+ / IQ 7X Micro Installation and Operation
enphase.com/en-us/support/contact.
Microinverter Communications LED
Device Scan button
141-00043-02