multicomp pro MP Dual Channel Series User Manual page 6

Warning:
If the input port of the oscilloscope is connected to a voltage with a peak value
higher than 42V (30vrms) or a circuit with a peak value of more than 4800 VA,
the following measures shall be taken to avoid electric shock or fire:
 Only voltage probes, test wires and adapters with proper insulation
attached to the oscilloscope or accessories suitable for oscilloscope
instrument series products specified by our company shall be used.
 Before use, check the multimeter test probe, oscilloscope probe and
accessories for mechanical damage. If damage available, replace it.
 Remove all unused multimeter test probes, oscilloscope probes and
accessories (power adapter, USB, etc.).
 Firstly, plug the power adapter into the AC socket, and then connect it to
the oscilloscope.
 When testing in a CAT II environment, do not connect a voltage higher
than 400 V to any input port.
 When testing in a CAT II environment, do not connect a voltage with a
voltage difference of more than 400 V to the isolated input port.
 Do not use an input voltage higher than the rated value of the instrument.
Pay special attention when using 1:1 test wires, because the probe voltage
will be directly transmitted to the oscilloscope.
 Do not touch the bare metal BNC or banana plug.
 Do not insert metal objects into the connector.
 Use the oscilloscope only in the specified way.
 The voltage rating mentioned in the "warning" information is the limited
value of "working voltage". They represent V ac rms (50-60 Hz) in AC sine
wave applications; and V dc in DC applications. CAT is the prefix, and II
refers to the level. Level II is the low voltage and high energy level, which
refers to the local electrical level applicable to electrical appliances and
portable equipment.
4