Maintenance And Servicing; Before Each Use; After Use - Chicago Electric 92880 Set Up And Operating Instructions Manual

MAInTEnAnCE AnD
SERVICIng
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FROM ACCIDEnTAL
OpERATIOn:
Turn the power Switch of the tool
off and remove the Battery pack
before performing any
inspection, maintenance, or
cleaning procedures.
TO pREVEnT SERIOuS InjuRY
FROM TOOL FAILuRE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and Lubrication

BEFORE EACh uSE,

1.
general condition of the tool. Check for
loose screws, misalignment or binding of
moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
2.

AFTER uSE,

the tool with clean cloth.
3. Periodically blow dust and grit out of the
motor vents using dry compressed air.
Wear ANSI-approved safety goggles and
NIOSH-approved breathing protection
while doing this.
4. A plastic storage case has been provided
for safe storage of your Rotary Tool and
its bits, parts and accessories. Always
SKU 92880
TO pREVEnT
SERIOuS InjuRY
inspect the
wipe external surfaces of
For technical questions, please call 1-800-444-3353.
store your tool and its accessories in the
case provided.
5. Protect the tool and its parts and
accessories from moisture and damp or
corrosive atmospheres.
6. Protect this tool from damage. Do
not leave it in a place where it can be
banged around, such as a truck bed or
vehicle trunk.
7. Some of the bits provided are "grinding
bits" using stone abrasives. During use,
these may clog up with removed material
or lose their shape. To clean and
reshape these bits, run them against the
provided Dressing Stone. The Dressing
Stone will abrade away the clogging
materials and will reshape the Grinding
Bits as appropriate.
8. NiCd BATTERy MUST BE RECyCLED
OR DISPOSED OF PROPERLy. Do not
short, incinerate or open battery.
9. WARnIng! If the supply cord of the
Transformer is damaged, it must be
replaced only by a qualified service
technician.
Accessory Storage and handling
1. Handle accessories carefully to prevent
dropping or bumping. Do not use wheels
that have been dropped or bumped.
2. Store accessories in carrying case.
Store in a dry area above freezing
temperatures. Any grinding or cut-off
wheels exposed to humidity or freezing
temperatures must not be used. Keep
all accessories out of reach of children.
Page 13