Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control. Protect others in the work area from debris such as chips and sparks. Provide barriers or shields as needed. SKU 90814 PAGE 2 REV 01/04...
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts. SKU 90814 PAGE 3...
Page 4
Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool’s operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly main- tained tools. SKU 90814 PAGE 4...
Avoid unintentional starting. Make sure you are prepared to begin work before turning on the tool. Do not force the tool. This tool will do the work better and safer at the speed and capacity for which it was designed. SKU 90814 PAGE 5 REV 01/04...
Page 6
(California Health & Safety Code 25249.5, et seq.) WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker. SKU 90814 PAGE 6...
Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See Figure A.) FIGURE A SKU 90814 PAGE 7...
(See Figure C.) If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (See Figure C.) SKU 90814 PAGE 8...
Page 9
*Based on limiting the line voltage drop FIGURE C to five volts at 150% of the rated amperes. SYMBOLOGY Double Insulated Canadian Standards Association Underwriters Laboratories, Inc. Volts Alternating Current Amperes No Load Revolutions xxxx/min. per Minute (RPM) SKU 90814 PAGE 9...
Page 10
1/2” Cold Chisel (4), 5/8” Chisel (5) and the 2” Chisel (6) are used for wood applications and making slots. The 1/2” Cold Chisel (4) is used for Light Duty cutting and dressing metal surfaces. REV 01/04 REV 02/04 SKU 90814 PAGE 10...
Page 11
Do not force the tool. Allow the tool to do the work. When you are finished, move the bit off of the workpiece, release the Trigger (7), and unplug the unit. SKU 90814 PAGE 11 REV 02/04...
Check the bits before you use the unit. Only use bits that are sharp. Never use a bit that is dull, cracked, or chipped. Have dull bits sharpened by a qualified technician. Discard chipped or cracked bits. SKU 90814 PAGE 12 REV 01/04...
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. REV 02/04 REV 01/04 SKU 90814 PAGE 13...