Table of Contents
Advertisement
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5.
Battery tool use and care
a.
Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire
when used with another battery pack.
b.
Use power tools only with specifically
designated battery packs. Use of any
other battery packs may create a risk of
injury and fire.
c.
When battery pack is not in use, keep
it away from other metal objects, like
paper clips, coins, keys, nails, screws
or other small metal objects, that can
make a connection from one terminal
to another. Shorting the battery
terminals together may cause burns or a
fire.
under abusive conditions, liquid
d.
may be ejected from the battery;
avoid contact. If contact accidentally
occurs, flush with water. If liquid
contacts eyes, additionally seek
medical help. Liquid ejected from the
battery may cause irritation or burns.
6.
Service
a.
have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
Safety Warnings grinding, Sanding,
polishing, or Abrasive Cutting
Operations
1.
This power tool is intended to
function as a grinder, sander,
polisher or cut-off tool. Read all safety
warnings, instructions, illustrations
Page 4
For technical questions, please call 1-800-444-3353.
and specifications provided with
this power tool. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious injury.
2.
Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
3.
The rated speed of the accessory
must be at least equal to the
maximum speed marked on the power
tool. Accessories running faster than
their RATED SPEED can break and fly
apart.
The outside diameter and the
4.
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
guarded or controlled.
5.
The shank of the accessories must
properly fit the Collet of the power
tool. Accessories with arbor holes that
do not match the mounting hardware of
the power tool will run out of balance,
vibrate excessively and may cause loss
of control.
6.
Do not use a damaged accessory.
Before each use inspect the
accessory such as abrasive wheels
for chips and cracks, backing pad for
cracks, tear or excess wear. If power
tool or accessory is dropped, inspect
for damage or install an undamaged
accessory. After inspecting and
installing an accessory, position
yourself and bystanders away from
the plane of the rotating accessory
and run the power tool at maximum
no-load speed for one minute.
REV 10e
SKU 92880
Hide quick links:
Advertisement
Table of Contents
