Advertisement
Standard Functions
NOTE:. Parameters marked with "" in A column are accessible even in inverter running.
Parameters marked with "" in B column are accessible even in inverter running when in
the high level access mode, which means that b031 is set to "10".
Func.
Name
Code
Frequency source
Frequency source,
nd
2
motor
Run command source
Run command source,
nd
2
motor
Base frequency
Base frequency,
nd
2
motor
Maximum frequency
Maximum frequency,
nd
2
motor
[AT] selection
[O] input active range
start frequency
[O] input active range
end frequency
"A" Function
Description
Eight options; select codes:
POT on ext. operator
*Valid when connecting the
OPE-SR/SRmini
Control terminal
*Set to "01" when connecting
the WJ-VL or External volume
via control terminal
Function F001 setting
Modbus network input
Option
via EzSQ
Calculate function output
Four options; select codes:
Control terminal
Run key on keypad, or
digital operator
Modbus network input
Option
Settable from 30 Hz to the
maximum frequency()
Settable from 30 Hz to the 2
maximum frequency()
Settable from the base
frequency to 400 Hz
Settable from the 2
frequency to 400 Hz
Three options; select codes:
...Select between [O] and
[OI] at [AT] (ON=OI,
OFF=O)
...Select between [O] and
external POT at [AT]
(ON=POT, OFF=O)
...Select between [OI] and
external POT at [AT]
(ON=POT, OFF=OI)
The output frequency
corresponding to the analog
input range starting point,
range is 0.00 to 400.0 Hz
The output frequency
corresponding to the analog
input range ending point,
range is 0.00 to 400.0 Hz
A
nd
nd
base
51
Defaults
B
Initial data
01
01
01
01
50.0
50.0
50.0
50.0
00
0.00
0.00
Units
Hz
Hz
Hz
Hz
Hz
Hz
Advertisement
