540Mm - Westinghouse WFE616 User Manual

INSTALLING THE APPLIANCE
Cabinet Requirements
This appliance has been designed to 'slot-in' to a 540mm
wide gap built-in standard kitchen cabinets. As such the
appliance can be installed to suit the height and depth
of benches and behind the kick rail of the cabinets. This
allows the cooker to integrate well into contemporary
kitchens. The cooker may also be installed at the end of
a line of benches or with a free space on either side.
• Electric hob models must not be installed in a corner;
they must be installed at least 100mm from the
side wall. Gas hob models must be installed with a
minimum clearance of 100mm to side walls made
of unprotected combustible materials.
• For gas models refer to section 6.10.1 in AS/NZS
5601.1 for all relevant clearances.
Clearance to side wall
(refer notes)
600mm min.
to combustible
material

540mm

910mm
WARNING
WARNING
In order to avoid accidental tipping of the appliance (for
example, by a child climbing onto the open oven door),
the anti-tilt plate and stabilising bolt MUST be installed.
28
INSTALLATION
(540mm wide product)
550mm
minimum
Anti-tilt plate
1 .25m electrical
service cord
(if fitted)
630mm
Rear cover
25mm to
side of plate
5mm clearance
Anti-tilt
plate
Rear adjustable foot
Position anti-tilt plate to the rear wall and 25mm from
side of cupboard. Securely fix anti-tilt plate to the floor
with fasteners. Adjust levelling feet on cooker as required.
Stabilising bolt
Stability
bolt
Kick-panel
Remove oven door - to be done by qualified personnel
only. (Refer to procedure).
2. Remove screws from kick panel. To remove kick panel
lift kick panel upwards to release the two location
tabs from the holes in the bottom of the panel.
3. Position cooker into the ant-tilt plate and then mark
the position for the stability bolt hole on the floor.
4. Pull cooker out and drill the bolt hole, using a 6.5mm
masonry or wood drill bit. The bolt hole needs to
be a minimum of 30mm deep when fixing the oven
to concrete.
5. Reposition cooker back into place and fit the stability
bolt through the slot and into the drilled hole.
6. If the cooker is placed on a base, measures must be
taken to prevent the appliance slipping from the base.
WARNING
WARNING
For your safety this cooker is designed to be moved out
of position by a qualified person only.
Installing Splashback
Fit splashback to rear of hob with the two
screws provided.
Front
6.5mm adjustable
feet
ø drilled
location hole