Advertisement
Follow these steps:
1. Click on the Airport icon on the top right menu.
2. Click on the network name that you want to connect.
3. On the new window, tick on Show Password and type in the network key in the Password field. Click on OK.
4. To check the connection, click on the Airport icon and there should be a tick on the wireless name.
Notes: For other operating system (Windows 98SE, Windows ME, Windows 2000 etc) or if you use the wireless
adaptor utility to configure your wireless connection, please consult the wireless adapter documentation for
additional information.
Appendix C: Troubleshooting
Using LEDs to Diagnose Problems
The LEDs are useful aides for finding possible problem causes.
Power LED
The Power LED does not light up.
Step
Correct Action
Make sure that the 3G25W-R power adaptor is connected to the device and plugged in to an appropriate power
1
source. Use only the supplied power adaptor.
Check that the 3G25W-R and the power source are both turned on and device is receiving sufficient power.
2
Turn the 3G25W-R off and on.
3
If the error persists, you may have a hardware problem. In this case, you should contact your vendor.
4
Web Configuration
I cannot access the web configuration.
STEPS CORRECTIVE ACTION
Step
Correct Action
1
Make sure you are using the correct IP address of the 3G25W-R. Check the IP address of the device.
2
Check that you have enabled web service access. If you have configured a secured client IP address, your computer's
IP address must match it.
3
Your computer's and the 3G25W-R's IP addresses must be on the same subnet for LAN access.
4
If you changed the devices WLAN IP address, then enter the new one as the URL.
The web configuration does not display properly.
S
Advertisement
