Advertisement
Get Community: Sets the community string your device will respond to for Read-Only access.
Set Community: Sets the community string your device will respond to for Read/Write access.
IP 1, IP 2, IP 3, IP 4: Input your SNMP Management host IP here. You will need to configure the address where the device should send SNMP
Trap messages to.
SNMP Version: Please select proper SNMP Version that your SNMP Management software supports.
WAN Access IP Address: You can limit remote access to a specific IP address by entering it here.
Please note: If "Remote" access is enabled, the default setting of 0.0.0.0 means any IP obtain SNMP protocol information.
Click on "Save" to store your setting or "Undo" to discard your changes.
Advanced Setting > Routing
Routing tables allow you to determine which physical interface address to use for outgoing IP data. If you have more than one router and subnet, you will need to configure the routing
table to allow packets to find the proper routing path and allow different subnets to communicate with each other.
These settings are used to setup the static and dynamic routing features of the 3G25W-R.
Advertisement
