Advertisement
You have purchased the router from someone else and need to reconfigure the
device.
You are asked to perform a factory reset by a member of the excellent NetComm
Support Staff.
In order to restore your router to its factory default settings, please follow these steps:
Ensure that the router is powered on (for at least 20 seconds).
Use a paper clip or a pencil tip to depress the reset button for ten seconds and
release. At this point, the reset is in progress. Do not power off the unit at this point.
After the router reboots, the default settings are now restored. This entire process
takes several minutes to complete.
Once you have reset the router to its default settings you will be able to access the
device's web configuration using http://192.168.1.1 with password "admin".
Default Settings
LAN (Management)
Static IP Address: 192.168.1.x
Subnet Mask:
Default Gateway: 192.168.1.1
WAN (Internet)
WAN mode:
Wireless
SSID:
Security:
WEP Key:
Modem Access
Password:
255.255.255.0
DHCP
(refer to the wireless security card insert)
WPA2-PSK
(refer to the wireless security card insert)
admin
Advertisement
