Installation Instructions - TESY CH 3420 60 G Instructions For Use And Maintenance Manual

RISK OF FIRE!
Installation of the range hood over an appliance
which runs on solid fuel (wood or coal) is allowed only
in case the appliance is permanently assembled. The
local regulations regarding the mains electricity shall be
observed.
If the appliance has not been cleaned in accordance with
the cleaning instructions it is possible to suck in sparkles
or other small burning particles and thus to cause fire.

INSTALLATION INSTRUCTIONS

The chimney-type range hood CH 3420 60 G is designed
for wall-mounting.
Figure 3 – Dimensions of the range hood and
installation of the non-return flap
Components of figure 3:
1. Ø150/120 mm adapter (optional)
2. 2 pcs. 3.5х9.5 mm screw
3. 150 mm non-return flap
4. Body
English
The installation of the non-return flap is done as follows:
1. Fix the non-return flap to the body of the range
hood by 2 screws 3.5х9.5 mm.
2. If you need the Ø150/Ø120 mm adapter, install it by
pressing it tightly to the non-return flap.
In figure 4 below You can see the components and the
installation holes.
Figure 4 – Drawing of components and installation
openings
1.
Internal chimney body
2. External chimney body
3. Glass
4. Attaching clamps
5.
Fixing screw for the attaching clamps
6.
Range hood body
7. 4 pcs 5.5х60 mm fixing screw for wall mounting
8. 4 pcs Ø10 mm wall plug
9. 2 pcs 3.9х22 mm screw
10.
Metal joint bar
11.
2 pcs Ø6 mm wall plug
•
Unscrew the screw and the attaching clamp (5) and
pull the rear panel (4) upwards, and then fix the
screws to secure the rear panel with the attaching
clamps.
•
Place the installation template on the wall at the
level of the indicated height (verify the minimum
and maximum distance in the installation drawing)
•
Drill openings A, B, C and D with Ø10 mm drill.
•
Drill openings E and F with Ø6 mm drill.
•
Insert Ø10 mm wall plugs (8) in openings A, B, C and
D, and in openings E and F Ø6 mm wall plugs (11).
•
Tighten the screws in points A and B, leaving 5 mm
distance between the head of the screw and the
wall.
•
Mount the range hood on the wall using the
attaching clamps.
Instructions for use and maintenance
EN
5