Removing the drive-bay heat sensor
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
stability
foot.
2. Remove the left and right side-panels. See
Procedure
1. Lay the chassis on the left side.
2. Locate the drive-bay heat-sensor connector (SENSOR1) on the system board. For more information on the drive-bay
heat-sensor connector, see
3. Disconnect the drive-bay heat-sensor cable from the connector on the system board.
a. drive-bay heat-sensor connector
b. drive-bay heat-sensor cable connector
44
Removing the drive-bay heat sensor
computer. After working inside your computer, follow the instructions in
"Removing the side
"System-Board
Components".
panels".
23
After
www.dell.com/