Removing The Drive-Bay Heat Sensor Cable; Prerequisites; Procedure - Dell Alienware Area-51 R4 Service Manual

Removing the drive-bay heat sensor cable

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Prerequisites

1. Remove the stability foot.
2. Remove the left and right side-panels. See

Procedure

1. Lay the chassis on the right side.
2. Disconnect the drive-bay heat-sensor cable from the system board.
a. drive-bay heat-sensor connector
b. drive-bay heat-sensor cable
3. Turn the chassis over.
4. Remove the cable through the slot on the chassis.
5. Locate the drive-bay heat-sensor. See
6. Push the release tab and pry the drive-bay heat-sensor cable off the chassis.
44
computer. After working inside your computer, follow the instructions in
"Removing the side panels".
"right view".
After working
www.dell.com/