Removing The Drive Bay - Dell Inspiron Zino HD 410 Service Manual

Back to Contents Page
Drive Bay
Dell™ Inspiron™ 410 Service Manual
Removing the Drive Bay
Replacing the Drive Bay
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Drive Bay
1. Follow the procedures in Before You
2. Remove the top cover (see
3. Remove the top bracket (see
4. Remove the optical drive (see
5. Remove the screw that secures the power-button bracket to the drive bay.
1 screw 2 power-button bracket
6. Without pulling hard on the power-button bracket, lift and hold the power-button bracket away from the drive bay.
7. Remove the two screws that secure the drive bay to the chassis.
8. Slide the drive bay towards the back of the computer and lift the drive bay to access the hard-drive cable.
9. Disconnect the hard-drive cable from the connector on the hard drive.
10. Carefully lift the drive bay away from the computer.
Begin.
Removing the Top Cover).
Removing the Top Bracket).
Removing the Optical Drive).