NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
Procedure
1. Tilt the computer towards the front until the base is facing up.
2. Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws
(#6-32x6).
Replacing the stability foot
computer. After working inside your computer, follow the instructions in
After
www.dell.com/
Replacing the stability foot
6
17