Replacing The Stability Foot; Procedure - Dell Alienware Area-51 R4 Service Manual

Replacing the stability foot

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1. Tilt the computer towards the front until the base is facing up.
2. Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws
(#6-32x6).
3. Tilt the computer back to the upright position.
22
computer. After working inside your computer, follow the instructions in After working
www.dell.com/