Matrox Veos User Manual page 15

2
Cause
The segment length of your coaxial cable may be too long.
1
Solution
Make sure the segment length of your coaxial cable is supported by your Matrox product. For
more information,
2
Solution
To add more distance, connect one or more Repeater units to your setup. For more
information, contact your Matrox representative.
3
Cause
The coaxial cable or connector you're using may not be supported by your Matrox product.
1
Solution
For more information on supported coaxial cables and connectors,
information", page
4
Cause
The connector on your cable may not be properly crimped.
1
Solution
Try re-crimping the connector on your cable.
Problem Content channel lights on Display unit are red
1
Cause
Your Display unit can't detect an input
signal.
1
Solution
Make sure the coaxial cable is properly connected to the input coaxial connector on your
Display unit and all connectors are properly fastened.
2
Cause
The coaxial cable you're using may not be supported by your Matrox product.
1
Solution
For more information on supported coaxial cables,
Problem Can't select one or more resolutions supported by your monitor
1
Cause
Windows may list certain display resolutions, even though they may not be supported by
your Matrox product.
1
Solution
Make sure your Matrox product supports the selected display resolution. For more
information, see Matrox PowerDesk help.
2
Solution
Make sure your Matrox software is installed. For more information,
page 13.
see "Product information", page
21.
21.
see "Product
see "Product information", page
see "Software setup",
Matrox Veos – User Guide 15
Content
channel
lights
21.