Table of Contents
Advertisement
The Prince Castle DHB-BK Bins and Retro Bun Timer and New Bun
Cabinet Timers can be inter-connected to form the CastleNet
Communication Network. The network can be used for data transfer
between bins and timers for menu updates or to transfer product hold
time from bin-to-bin. A PDA (or similar device) or a notebook with Prince
Castle MenuView
software is used to connect to the network and enter
®
the desired changes.
Each bin is supplied with a standard 25' cable and allows units to be
"daisy-chained" together to form the network. If cable is too short, use
Prince Castle Extender Cable Kit, P/N PC-COMEXT.
The factory default address for Main bins and timers is address 1.
The factory default address for Specialty bins and timers is address 2.
If a third bin is used, the address must be set at 3.
The factory default address for the Retro Bun Timer is bunF.
IMPORTANT: Each timer must have a different address.
2
If a location has three bins, it is recommended that the bins
and timers be set consecutively to addresses 1 through 3.
Bin 1
Example
Use the UP or DOWN Arrow buttons to scroll to the desired
4
address. Press the PRINCE CASTLE LOGO Button to store the
new address.
Available addresses are:
bin1 thru bin9, binA, binB, binC, binD, binE
and binF.
IMPORTANT: Continue to step 5 to
check the timer address. No two
timers can have the same address.
To change the timer address, turn the unit power switch off and
6
wait 15 seconds. Turn the power switch back on and immedi-
ately press and hold the PRINCE CASTLE LOGO button and the
DOWN Arrow button for approximately 6 seconds or until the
display shows SET ADDR ⇑ ⇓ BAR2.
The address number will blink on/off.
TRANSFER
ADDR
SET
Printed in USA 10/10 © 2010
CastleNet® Communications Network
®
Bin 3
Bin 2
UPPER
bar3
PROG
LOWER
ACTUAL
TEMP
SET-
POINT
⇑
bar2
Telephone jack plugs are located on the back of the unit.
1
Connect the units using the cables provided as shown here.
BIN 1
EXTERNAL
IN
OUT
A. Turn the power switch off, wait 15 seconds. Turn the switch
3
to ON while pressing and holding the ACTUAL and SET-
POINT buttons. The display will show the current bin
address.
B. Continue to hold the buttons until PROG LED turns on.
UPPER
bar2
PROG
LOWER
ACTUAL
TEMP
SET-
POINT
To check the timer address, press and hold the PRINCE
5
CASTLE LOGO button and the DOWN Arrow button.
The current timer address will be displayed in the far right timer
display.
To change the timer address, proceed to step 6.
EGGS
EGGS
Use the UP or DOWN Arrow button to scroll to the desired
7
address. Press the MENU/ENTER button to store the new
address and return to normal operating mode.
Available addresses are:
bin1 thru bin 9, binA, binB, binC, binD, binE and binF.
ADDR
MENU
ENTER
10
Product Holding Bin
DHB2PT-33DQ Series
BIN 2
BIN 3
RETRO
BUN
TIMER
EXTERNAL
EXTERNAL
IN
OUT
IN
OUT
Example
UPPER
prog
PROG
LOWER
ACTUAL
TEMP
SET-
POINT
TRANSFER
bar2
EGGS
MENU
⇑
bar3
ENTER
541-553revC_EN
MENU
B
RE
ENTER
BKFT
REG
Advertisement
Table of Contents
