Table of Contents
Advertisement
Mounting and adjusting the lens
Mounting the lens
Lens lever
Mount cap
1
Raise the lens lever and remove the mount cap. (Fig. 1)
2
Align the indentation at the top center of the lens mount with the center mark of the lens to mount the lens. (Fig. 2)
3
Lower the lens lever to firmly clamp the lens. (Fig. 3)
4
Secure the cable through the cable clamp and connect it to the <LENS> terminal. (Fig. 4)
5
Perform lens flange back adjustments.
For details, refer to "Lens flange back adjustment" (page 31).
@
NOTE
t For handling the lens, refer to the lens operating instructions.
t For details on the current from the <LENS> terminal, refer to "Details of the connector signals" (page 224).
t When the lens is removed, install the mount cap to protect the device.
Lens flange back adjustment
If images are not clearly focused at both telephoto and wide-angle positions during zoom operations, adjust the lens flange back (distance from the lens
mounting surface to the image formation surface).
Once adjusted, the lens flange back does not need to be readjusted until the lens is changed.
@
NOTE
t Refer to the lens operating instructions for guidance on adjustment methods and positions of lens parts.
Chapter 3 Preparation — Mounting and adjusting the lens
Fig. 1
Fig. 3
– 31 –
Mark
Fig. 2
Cable clamp
<LENS> terminal
Fig. 4
Advertisement
Table of Contents
