Table of Contents
Advertisement
During USB host mode
Message
[CANNOT ACCESS CARD!]
[CANNOT ACCESS TARGET!]
[CANNOT COPY!][FORMAT STORAGE
DEVICE TO FAT]
[CANNOT FORMAT!]
[CANNOT RECOGNIZE STORAGE
DEVICE!]
[CANNOT SELECT!][MAX. 6 PARTITIONS]
[CARD IS EMPTY! CANNOT COPY!]
[FORMAT P2 CARD!]
[LACK OF CAPACITY!]
[MISMATCH COMPONENT!]
[STORAGE DEVICE DISCONNECTED!]
[TOO MANY PARTITIONS!]
[UNKNOWN DEVICE CONNECTED!]
[VERIFICATION FAILED!]
Network
Message
[CANNOT CONNECT!]
[CANNOT FIND FTP-SERVER!]
[LOGIN FAILED!]
[PING FAILED!]
[CANNOT ACCESS GATEWAY!]
[CHECK LAN SETTING]
[IP ADDRESS IS USED!]
[INVALID VALUE!]
[ENCRYPTION IS NOT SUPPORT!]
Chapter 11 Maintenance — Warning system
Description
An error occurred while accessing the P2 card.
An error occurred while accessing the connection target. Check the storage device status and connection.
The partition that can copy clips does not exist on the
storage device.
The storage device cannot be formatted.
The storage device is not correctly recognized.
Storage devices with more than six partitions cannot be
selected (mounted simultaneously).
The P2 card to copy is empty.
Cannot import to a P2 card containing clips.
Not enough space left on the storage device.
The P2 card model number of the copy source and copy
destination do not match. Cannot copy.
The connection with the storage device is disconnected.
There are too many partitions.
A non-compatible DVD drive or other device is
connected.
The compare check performed after copying failed.
Description
A connection to the network cannot be established.
The connection destination FTP server cannot be found.
Logging in to the connection destination FTP server
failed.
The [PING] failed.
The gateway server cannot be accessed.
The gateway server cannot be accessed.
The set IP address is being used by another device.
The entered data value is invalid.
Encryption is not supported.
– 217 –
Measure
Check the P2 card.
Reformat in FAT format, or export the P2 card to create
a partition.
Change the connected storage device.
Reboot the storage device or connect another storage
device.
Release selected partitions.
The copy operation is not performed because the card
is empty.
Format the P2 card.
Use a new storage device with sufficient available space
or a formatted storage device.
Use the P2 cards of the same model number, or import
on a clip basis.
Reconnect the USB cable to the <USB2.0> terminal
(host). When it does not function normally after that, turn
off the power once and turn on the power again.
The maximum number of partitions on the storage
device is 23. Either reformat, or use a new storage
device.
Change the connected device to the correct storage
device, and then turn off the power once and turn on it
again.
Copy it again.
Measure
Check that the LAN settings are correct. Check that the
LAN cable is connected correctly and the network you
use is running.
Check that the setting in the main menu → [NETWORK
SETUP] → [FTP CLIENT SERVICE] → [SERVER URL]
is correct.
Check that the settings in the main menu →
[NETWORK SETUP] → [FTP CLIENT SERVICE] →
[LOGIN USER] and [LOGIN PASSWORD] are correct.
Check that the LAN setting and the setting in the
main menu → [NETWORK SETUP] → [FTP CLIENT
SERVICE] → [SERVER URL] are correct. Check that
the LAN cable is connected correctly and the network
you use is running.
Check that the LAN settings are correct.
Check that the LAN settings are correct.
Consult your network administrator and set another IP
address.
Enter data in a valid range.
Check the encryption setting on the destination.
Advertisement
Table of Contents
