Canvas (Optional) - Quicksilver 675WE Owner's Manual

Quicksilver 675WE — System & Component Overview and Operation
sunshade rail in place. To extend the sunshade, simply pull the pin on both sides and slide the rail out.
The pins will re-engage and lock the rail when fully extended. To install the sunshade canvas, slide the
welting (piping) located on front edge of the sunshade through the sunshade track installed on the
hardtop. Next connect the sunshade to the sunshade rail using the zippers on the edge of the
sunshade. Finally, connect the sunshade straps to the eyelets on the deck.
Cockpit Sunshade
Sunshade rail
Pull pin (P&S)
Sunshade canvas

24. Canvas (optional)

As an option, a bimini with frame and a bimini with a frame and vinyl panels that fully encloses the
cockpit can be installed on your boat.
Bimini
When not in use, the bimini can be stored in an aft position where it does not interfere with the use of
the boat. In this position, always make sure that the bimini is secured in the canvas boot. To use the
bimini, remove the canvas boot, rotate the bimini frame forward and secure the canvas to the
hardtop.
Bimini with Enclosure
In addition to the bimini, clear vinyl panels can be installed to enclose the cockpit. Each panel attaches
to the bimini with a zipper and snaps or studs are used to attach to the deck.
Sunshade strap (P&S)
Deck eyelets
In rough seas, the sunshade should be stored to avoid
damage to the rail and or canvas
42