Table of Contents
Advertisement
Quicksilver 755OP — System & Component Overview and Operation
To complete the sun lounge, you must install the filler panels located on the forward console seat and
the port and starboard cockpit walls. Rotate the plastic panel located on the forward console until it
rests on the aft edge of the table. Now, unclip the plastic panels located on port and starboard cockpit
wall and rotate the panels down until it rests on the edge of the console and bow seats. Finally, install
the cushions.
Along with the table, the cushions store in the cabin when not in use.
Sun Lounge
Sun lounge w/ table lowered
Sun lounge with fillers boards installed
24. Canvas (optional)
As an option, a bimini with a frame, a bimini with vinyl panels that fully encloses the cockpit, and a
forward sun awning can be installed on your boat.
Bimini
When not in use, the bimini can be stored in an aft position where it does not interfere with the use of
the boat. In this position, always make sure that the bimini is secured in the canvas boot. To use the
Sun lounge with cushions installed
39
Bow cockpit table
Table support leg
Console filler board
Port filler board
Starboard filler board
Console filler pad
Port filler pad
Starboard filler pad
Bow table filler pad
Forward console cushion
Port bow seat cushion
Starboard bow seat cushion
Center bow seat cushion
Advertisement
Table of Contents
