Cautions - Hitachi CM715U User Manual

CAUTIONS

NEVER REMOVE THE REAR COVER !
The rear cover MUST be removed only by authorized service personnel. This color monitor contains
high voltage components.
THE RECEPTACLE SHOULD BE CLOSE TO THE MONITOR AND EASILY ACCESSIBLE !
INSTALL THE UNIT IN A SUITABLE ENVIRONMENT !
DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard. This unit is
designed to be used in an office or business environment.
DO NOT subject the unit to vibrations, dust, or corrosive gases.
KEEP IN A WELL VENTILATED PLACE !
DO NOT cover this monitor or place anything against any sides (not only the top, right and left side
but also the rear and bottom side) of unit. Ventilation holes are provided at all sides of the rear cover
to prevent the temperature from rising.
KEEP AWAY FROM HEAT SOURCES !
AVOID placing the unit in direct sunshine or near a heating appliance.
BE CAREFUL OF MAGNETIC FIELDS !
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything which will
generate magnetism near the unit. A magnetic field may cause blurred colors or distortion of the
displayed pattern.
BE CAREFUL OF GENERATED MAGNETISM !
After the power has been turned on or the "DEGAUSS" button has been pressed, the CRT is
demagnetized for approximately 10 seconds. This generates a strong magnetic field around the front
cover which may affect the data stored on magnetic tape or disks near the front cover. Place such
magnetic recording equipment and tapes/disks away from this unit.
AMBIENT ILLUMINATION
Avoid direct rays of the sun or room lighting onto the CRT screen in order to prevent eye fatigue.
THE ENCLOSED POWER CORD MUST BE USED !
In Europe, a proper European standard approved power cord is to be used with this monitor.
rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm
must be used.
In USA/Canada, use a UL LISTED/CSA LABELLED or CERTIFIED power cord set meeting the
following specifications
Rating: min. 125V, 7A
Length: max. 3.0m
Type: SVT or SJT
Plug type: NEMA 5-15P figure, Parallel blade, Grounding type
Failure to do so may cause fire or electric shock hazard.
USE ONLY THE CORRECT VOLTAGE POWER OUTLET WITH SAFETY GROUND
CONNECTION !
100 - 120 V for USA, Canada, etc.
200 - 240 V for Europe, etc.
(This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.)
2
3
or H05VVH2-F 3G 0.75 mm
For a
2