VESA DPMS. ® The E emblem does not represent EPA endorsement of NERGY any product or service. ® As an E Partner, Hitachi,Ltd. has determined that this NERGY ® product meets the E guidelines for energy efficiency. NERGY...
Table of Contents Introduction ..............2 Features Package Overview Cautions ..............3 FCC Statement Warning ..........5 TCO'99 Statement ............7 For the Customers in the UK .........10 Limited Warranty for USA Customers Only.....11 For Canadian Customers only Warranty Policy ....13 Installation..............14 User Controls ............
Please save this packing material in case the monitor needs warranty service in the future. You must return the monitor in its original packing materials for warranty service or you will be required to purchase new packing materi- als that comply with Hitachi’s packaging standards.
CAUTIONS NEVER REMOVE THE REAR COVER ! The rear cover MUST be removed only by authorized service personnel. This color monitor contains high voltage components. THE RECEPTACLE SHOULD BE CLOSE TO THE MONITOR AND EASILY ACCESSIBLE ! INSTALL THE UNIT IN A SUITABLE ENVIRONMENT ! DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.
CAUTION for 200 - 240V operation only This equipment relies on the protective devices in the building installation for short-circuit and over- current protection. Refer to the following table for the suitable number and location of the protective devices which should be provided in the building installation. Informative examples of protective devices in single - phase equipment or sub - assemblies Protection...
CAUTIONS (Continued) FCC Statement Warning WARNING : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
TCO'99 Statement Congratulations! You have just purchased a TCO'99 approved and labelled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products. This product meets the requirements for the TCO'99 scheme which provides for an international environ- mental and quality labelling of personal computers.
Below you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from: TCO Development SE-114 94 Stockholm, Sweden Fax: +46 8 782 92 07 Email (Internet) : firstname.lastname@example.org Current information regarding TCO'99 approved and labelled products may also be obtained via the Internet, using the address: http://www.tco-info.com/ Environmental requirements...
**Lead, Cadmium and Mercury are heavy metals which are BIO-accumulative...
CAUTIONS (Continued) For the Customers in the UK THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE. FOR THE UK PLEASE REFER TO THE NOTES ON THIS PAGE. IMPORTANT FOR UNITED KINGDOM WORDING FOR CLASS EQUIPMENT INSTRUCTION BOOKS AND LABELS The mains lead on this equipment is supplied with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of the plug.
1/31/01. In the event of a defect during this 12 month, 36 month or 60 month period, Hitachi America, Ltd. will, at its option, repair or replace the monitor at no charge except as set forth below. If proof of purchase cannot be provided by owner, the warranty period will start to run from the date of manufacture.
LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING ANY LOST SAVINGS, LOST PROFITS, OR ANY OTHER DAMAGES CAUSED BY THE USE OF THIS MONITOR OR INABILITY TO USE IT, EVEN IF THE DEALER OR HITACHI AMERICA, LTD. HAS BEEN ADVISED OF SUCH LIABILITY OR OTHER CLAIMS.
Company is authorized to change, modify, or extend its terms in any manner whatsoever. Hitachi Canada Inc. shall not be responsible for any damages or loss of any kind attributed to the product rendered defective during usage, or attributed to incompatibility problems of any linked equipment including software.
INSTALLATION 1. Connect the monitor signal cable to the 15-pin mini D-sub (VGA) on the computer. 2. Connect the power cord to the power connector on the back panel of the monitor, then plug the other end into an appropriately grounded electrical outlet that is easily accessible and close to the monitor.
USER CONTROLS 1 Power Switch 2 Power LED Indicator LED Color State Turn monitor on Green and off. Yellow Sleep 3 Select button 4 Adjustments For adjusting the display For selecting OSD parameters in the selected functions. function.
OSD FUNCTION DESCRIPTION Press any buttons to display the OSD menu. To select function, press the buttons until the function you want is highlighted. Use the buttons to increase or decrease the adjustment of this func- tion. Select the (Exit) icon if you want to exit the OSD function then press the button once.
OSD ICON SUMMARY Icon Function Function Description Brightness Adjusts display brightness Contrast Adjusts display contrast H. Size Increases and decreases screen width H. Position Shifts display image right or left V. Size Increases and decrease screen height V. Position Shifts display image up or down Pin.
SPECIFICATIONS Screen Size 19" CRT Horizontal dot pitch 0.20 mm Horizontal mask pitch 0.19 mm Surface Non-glare Viewable Image Area (mm) 366 x 274 Input Signal Video signals. RGB Analog 0.7Vp-p / 75 Ohm a. Separate H/V, TTL (+/-) b. Composite H+V, TTL (+/-) Scanning Frequency Horizontal (KHz) 31 - 95...
TROUBLESHOOTING The following are solutions to common installation problems. If the symptom remains after trying the suggested solutions, please contact HITACHI technical support or refer to www.hitachidisplays.com for additional service and support information. Problem: Power LED is not lit when monitor is powered on.
Technical Support : 1 - 800 - 536 - 6721 World Wide Web Home page : http://www.hitachidisplays.com In Canada : 1 - 800 - HITACHI or 905 - 821 - 4545 World Wide Web Home page : http://www.hitachi.ca All Rights Reserved...