For The Customers In The Uk - Hitachi CM715U User Manual

CAUTIONS (Continued)

For the Customers in the UK

THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE.
FOR THE UK PLEASE REFER TO THE NOTES ON THIS PAGE.
WORDING FOR CLASS EQUIPMENT INSTRUCTION BOOKS AND LABELS
The mains lead on this equipment is supplied with a moulded plug incorporating a fuse, the value of
which is indicated on the pin face of the plug. Should the fuse need to be replaced, an ASTA or BSI
approved BS 1362 fuse must be used of the same rating. If the fuse cover is detachable never use
the plug with the cover omitted. If a replacement fuse cover is required, ensure it is of the same colour
as that visible on the pin face of the plug. Fuse covers are available from your dealer.
DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power
outlets in your home or the cable is too short to reach a power outlet, then obtain an appropriate safety
approved extension lead or consult your dealer.
Should it be necessary to change the mains plugs, this must be carried out by a competent person,
preferably a qualified electrician.
If there is no alternative to cutting off the mains plug, ensure that you dispose of it immediately, having
first removed the fuse, to avoid a possible shock hazard by inadvertent connection to the mains supply.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green & Yellow to Earth
Blue to Neutral
As these colours may not correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured GREEN and YELLOW must be connected to the terminal in the plug which
is marked with the letter E or by the earth symbol
The wire coloured BLUE must be connected to the terminal marked with the letter N or
coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal marked with
the letter L or coloured BROWN or RED.
NOTE:
The information in this manual is subject to change without notice. The manufacturer assumes
no responsibility for any errors that may appear in this manual.
TRADEMARK ACKNOWLEDGEMENT
VGA is a registered trademark of International Business Machines Corporation.
VESA is a trademark of a nonprofit organization, Video Electronics Standard Association.
® is a U.S. registered mark of Environmental Protection Agency (EPA).
E S
NERGY TAR
IMPORTANT FOR UNITED KINGDOM
WARNING: THIS EQUIPMENT MUST BE EARTHED
Green and Yellow = Earth, Blue = Neutral, Brown = Live.
or coloured GREEN or GREEN and YELLOW.
7
Brown to Live
Fuse
Cord Clamp