Table of Contents
Advertisement
CAUTIONS
NEVER
The rear cover MUST be removed only by authorized service personnel. This colour monitor contains
high voltage components.
THE RECEPTACLE SHOULD BE CLOSE TO THE MONITOR AND EASILY
ACCESSIBLE !
INSTALL
THE
DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.
designed
to
be
DO NOT subject the unit to vibrations, dust, or corrosive gases.
KEEP
IN
DO NOT cover this monitor or place anything against any sides (not only the top, right and left side but
also the rear and bottom side) of unit. Ventilation holes are provided at all sides of the rear cover to
prevent the temperature from rising.
KEEP
AWAY
AVOID placing the unit in direct sunshine or near a heating appliance.
BE
CAREFUL
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything which will
generate magnetism near the unit. A magnetic field may cause blurred colours or distortion of the
displayed pattern.
BE
CAREFUL
After the power has been turned on or "DEGAUSS" button has been pressed, the CRT is
demagnetized for approximately 10 seconds. This generates a strong magnetic field around the front
cover which may affect the data stored on magnetic tape or disks near the front cover. Place such
magnetic recording equipment and tapes/disks away from this unit
AMBIENT
Avoid direct rays of the sun or room lighting onto the CRT screen in order to prevent eye fatigue.
THE
ENCLOSED
In Europe, a proper European standard approved power cord is to be used with this monitor.
rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm
must be used.
In USA/Canada, use a UL LISTED/CSA LABELLED or CERTIFIED power cord set meeting the
following
Rating:
Length:
Type:
Plug type: NEMA 5-15P figure, Parallel blade, Grounding type
Failure to do so may cause fire or electric shock hazard.
USE ONLY THE CORRECT VOLTAGE POWER OUTLET WITH SAFETY
GROUND
100
-
120
200
-
(This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.)
2
REMOVE
THE
UNIT
IN
used
in
A
WELL
FROM
OF
OF
POWER
min.
SVT
V
240
V
REAR
AN
SUITABLE
an
office
or
VENTILATED
HEAT
MAGNETIC
GENERATED
.
CORD
MUST
2
125V,
max.
or
CONNECTION
for
USA,
for
COVER
ENVIRONMENT
This unit is
business
environment.
PLACE
SOURCES
FIELDS
MAGNETISM
ILLUMINATION
BE
USED
or H05VVH2-F 3G 0.75 mm
specifications
Canada,
Europe,
!
!
!
!
!
!
!
For a
2
7A
3.0m
SJT
!
etc.
etc.
Advertisement
Table of Contents
