Cautions - Hitachi CM821FET User Manual

CAUTIONS

Discontinue Use if Abnormal Operation Occurs !
Abnormal operations such as smoke, burning smell, excessive sound, etc. could cause
fire or electrical shock. If you observe any abnormal operation, you should turn off the
monitor and disconnect the power plug from the power outlet. You should check for
smoke or fire and contact your dealer.
Do not expose the monitor to physical impact !
Do not allow foreign objects (water, metal, etc.) inside !
Never remove the cover of the monitor!
This colour monitor contains high voltage components. Ask your dealer to repair or clean
the inside if necessary
The power outlet should be close to the monitor and easily accessible !
Install the unit in an suitable environment !
Do not expose the monitor to rain, moisture, dust, corrosive gases, vibrations, etc. to
prevent electrical shock or fire hazard.
Avoid placing the monitor in direct sunlight or near heating appliances.
Do not place the monitor on an unstable base.
Keep in a well ventilated area !
Do not cover this monitor, nor place anything against any of its sides (not only the top, but
also including the right and left side of the monitor). The ventilation holes in the cover
prevent excessive temperatures inside the monitor.
Beware of magnetic fields !
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or any appliance
which generates a magnetic field near the unit. A magnetic field may cause blurred
colours or distortion of the displayed pattern.
Mind the ambient illumination !
Avoid direct sunlight or artificial light shining directly onto the CRT screen in order to
prevent eye fatigue.
Enclosed power cord must be used !
Failure to do so may cause fire or electrical shock hazard.
Use only the correct voltage power outlet with grounded connection !
This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.
Beware of the power cord connection !
Before inserting the plug of the power cord into a power outlet of the correct voltage, check
that the connection portion of the power cord is clean (with no dust). Then, insert the plug
of power cord into a power outlet firmly to avoid electrical shock or fire hazard.
Remove the power cord for complete disconnection !
For complete disconnection from the power source, remove the power cord from either the
monitor or wall socket.
1 - 3