Advertisement
Step 8
P21
The wall panels come in two widths.
Each wall panel has a crimped rib on
one side. The crimped rib should go
under the rib of the panel that follows
it.
1
Locate all of the wall panels and
set each one alongside the building.
2
Be sure that you have the correct
panels in each position. Do this by
overlapping the panels and deter-
mining if the holes line up with the
holes in the frame.
3
Fasten the wall panels at the top
and bottom with screws.
4
Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs using a bolt and nut
with two screws.
5
When you have attached all wall
panels in the correct positions, the
building will look like this.
● Parts Needed For ●
Wall Panels
STEP
1
6515
6515
Panels rest on
frame as shown
Crimped Rib
Underneath
STEP
3
Use bolts and
nuts thru wall
angle overlap
at the top of
panel at rear.
STEP
5
● ● ● ● ● 6515 Wall Panel (4)
● ● ● ● ● 6243 Wall Panel (2)
6243
6243
Detail Showing
Center of Panel
Screwed to
Wall Channel
STEP
4
STEP
2
6515
6515
Bolt and nut
does not go thru
wall channel
at overlap
21
Advertisement
