Canon LEGRIA HF G60 Instruction Manual page 18

Preparing the Power Supply
3 Charging will start when the camcorder is turned off.
• The POWER/CHG (charge) indicator will illuminate in red while the battery is charging. If the POWER/CHG
indicator starts flashing, refer to Troubleshooting (A 109).
18
4 When the POWER/CHG indicator goes out, the battery is fully charged.
• Disconnect the compact power adapter from the camcorder and unplug the power cord.
To remove the battery pack
1 Slide the BATTERY RELEASE switch in the direction of the arrow
and hold it pressed down.
2 Slide the battery pack down and then pull it out.
IMPORTANT
• Do not connect to the compact power adapter any product that is not expressly recommended for use with
this camcorder.
• Turn off the camcorder before connecting or disconnecting the compact power adapter. After you turn off the
camcorder, important data is updated on the SD card. Be sure to wait until the green POWER/CHG indicator
goes out.
• When using the compact power adapter, do not fix it permanently to one place as this may cause a
malfunction.
• To prevent equipment breakdowns and excessive heating, do not connect the supplied compact power
adapter to voltage converters for overseas travels or special power sources such as those on aircraft and
ships, DC-AC inverters, etc.
NOTES
• We recommend charging the battery pack in temperatures between 10 °C and 30 °C. If either the ambient
temperature or the battery pack's temperature is outside the range of approx. 0 °C to 40 °C, charging will not
start.
• The battery pack will be charged only when the camcorder is off.
• If the power supply was disconnected while charging a battery pack, make sure the POWER/CHG indicator
has gone out before restoring the power supply.
Illuminated in red while
the battery is charging