INSTALLATION
If you don't want to use the Installation Wizard from the CD-ROM,
follow the instructions below. For advanced configurations, refer to
Section 3:Configuration.
Wired Connection to Access Point
Reset
Antenna
Power
LAN
This section applies if you are connecting your PC with an Ethernet
cable to the Access Point. Your PC must be installed first with an
Ethernet adapter.
You need one Ethernet cable for this procedure, to connect the PC to the Access
Point.
1
Using the supplied Ethernet cable, connect one end of the cable
to your PC's Ethernet adapter and the other end to the LAN port
on the Access Point. You are now able to configure the Access
Point.
2
To configure the initial settings of the Access Point, please see
Configure your Computers.
SECTION 2, INSTALLATION
SECTION 2
2-7