Table of Contents
Advertisement
SECTION 2
2-20
2
Enter the User ID. The default factory setting is "admin", without
the quotation marks.
3
Enter the Password. The default factory setting is "motorola",
without the quotation marks.
Once you have logged in, for security reasons, you should change the User ID and
Password. See Wireless Security Setup.
4
Click the Log In button to enter the AP's Web-based
Configuration Utility.
Wireless Security Setup
Follow these procedures to setup the correct security protocols for
your AP.
1
Select Control Panel > Device Security.
2
In the Change User ID field, enter in the desired Login User ID.
For strong security, select an ID that contains multiple of
case-sensitive characters as well as numbers. It cannot be longer
than 64 characters.
3
In the Change User Password field, enter in the desired Login
Password. For strong security, select a password that contains
multiple of case-sensitive characters as well as numbers and
symbols like "_ + )". It cannot be longer than 64 characters.
4
Re-enter the same Password.
5
Click Apply.
6
Once the settings have been accepted, click Restart and log
back into the Configuration Utility using your new User ID and
Password.
7
Navigate to Wireless > Basic.
8
Change the SSID to a user-friendly name and click Apply.
9
Navigate to Wireless > Security.
10 Select WPA-PSK from the drop down list of ESS Authentication.
11 Select AES from the drop down list of Encryption Status.
12 Enter a new Pass Phrase and again in Pass Phrase Confirm.
Remember this Pass Phrase so that you can enter the same
phrase for the Motorola client devices on your wireless LAN. Pass
Phrase must be between 8 and 63 characters.
13 Click Apply and then Restart. Your wireless configuration is now
complete.
SECTION 2, INSTALLATION
INSTALLATION
Advertisement
Table of Contents
