Daikin Altherma EPGA16DAV3 Installer's Reference Manual page 48

8 Configuration
# Code
[3.5] [0-00] Set weather-dependent heating:
T t
[0-01]
[0-02]
[0-01]
[0-03]
[0-00]
▪ T : Target leaving water temperature
t
(additional zone)
▪ T : Outdoor temperature
a
▪ [0-03]:
temperature. –40°C~+5°C
▪ [0-02]:
temperature. 10°C~25°C
▪ [0-01]:
temperature
temperature equals or drops below the
low
[9‑05]°C~[9‑06]°C
Note: This value should be higher
than
temperatures
required.
▪ [0-00]:
temperature
temperature equals or rises above the
high
[9‑05]~min(45, [9‑06])°C
Note: This value should be lower than
[0‑01]
temperatures less warm water is
required.
Cooling WD curve
Set weather-dependent cooling for the main zone (if [3.4] = 2):
Installer reference guide
48
Description
[0-03] [0-02]
T a
Low outdoor ambient
High outdoor ambient
Desired leaving water
when the outdoor
ambient temperature.
[0‑00] as for low outdoor
warmer water is
Desired leaving water
when the outdoor
ambient temperature.
as for high outdoor
# Code
[3.6] [0-04] Set weather-dependent cooling:
T t
[0-05]
[0-06]
[0-05]
[0-07]
[0-04]
▪ T : Target leaving water temperature
t
(additional zone)
▪ T : Outdoor temperature
a
▪ [0-07]:
temperature. 10°C~25°C
▪ [0-06]:
temperature. 25°C~43°C
▪ [0-05]:
temperature
temperature equals or drops below the
low
[9‑07]°C~[9‑08]°C
Note: This value should be higher
than
temperatures
required.
▪ [0-04]:
temperature
temperature equals or rises above the
high
[9‑07]°C~[9‑08]°C
Note: This value should be lower than
[0‑05]
temperatures colder water is required.
Emitter type
For more info about this functionality, see
page 43.
# Code
[3.7] [2‑0D] Emitter type
▪ 0: Underfloor heating
▪ 1: Fancoil unit
▪ 2: Radiator
The setting of the emitter type has an influence on the space heating
setpoint range and the target delta T in heating as follows:
Emitter type Space heating
Additional zone setpoint range
[9‑05]~[9‑06]
0: Underfloor heating Maximum 55°C
1: Fancoil unit Maximum 55°C
2: Radiator Maximum 65°C
Setpoint range
For more information about this setting, also see
zone" on page 43.
# Code
Leaving water temperature range for the additional leaving water
temperature zone (= the leaving water temperature zone with the
highest leaving water temperature in heating operation and the
lowest leaving water temperature in cooling operation)
[3.8.1] [9-05] Heating minimum: 15°C~37°C
EPGA11~16DAV3 + EAVZ16S18+23DA6V+9W
Description
[0-07] [0-06]
Low outdoor ambient
High outdoor ambient
Desired leaving water
when the outdoor
ambient temperature.
[0‑04] as for low outdoor
less cold water
Desired leaving water
when the outdoor
ambient temperature.
as for high outdoor
"8.4.3 Main zone" on
Description
Target delta T in
heating [1‑0C]
Variable (see [2.B])
Variable (see [2.B])
Fixed 8°C
"8.4.3 Main
Description
Daikin Altherma – Low temperature split
4P556075-1 – 2019.02
T a
is